Prosolar Foam
Jack
|
 Foam
Jack Test Data
Pull tested by an independent and accredited ICC approved
testing
laboratory to 2,870 lbs vertical and 2,615 axial (side) pull.
Test conducted with a 3/8” x 6” lag bolt in a 4”
x 6” Douglas Fir wood beam.
Measurements
/ Specifications
• BASE: 1.5” dia. x 2.6” #6061 Aluminum
• 1/4” hole for self tapping-screw base
• 3/8” hole for lag bolt base
POSTS: 1” dia. x 3” #6061 Aluminum
• 3/8” drilled & tapped (non-leveling version)
• 1/2” threaded 2” deep (leveling version)
|
 |
 |
The patented
design of the Fast Jack® is now available in an easy-to-foam
version designed for use on commercial and metal rooftops
This industrial
grade stanchion offers a full 2,870 lbs. of vertical strength using
one 3/8" x 6" lag bolt!
It also offers
an impressive 2,615 lbs. of axial (side) strength. Like the Commercial
and Residential Fast Jack, the primary connection to the roof is
made directly under the point of load.
The Foam Jack
base accepts one fastener up to 3/8” diameter. The 3/8"
threaded post version integrates with the Roof Trac support rail.
The post is
also available in a 1/2" thread version which fully integrates
with commercially available steel strut using the optional Commercial
Leveling Kit.
Benefits
of the Foam Jack:
• Patented
design locates the lag bolt or self tapping screw directly under
the removable post for superior strength
• Use of foam versus a flashing provides leak-free connections
at a fraction of the cost of conventional flashings
• Precision machined from extruded aluminum and tumbled clean
for proper foam adhesion
• Significantly lighter than steel for installer convenience
and reduced shipping costs
• Cylinder base design allows for even distribution of foam
around the stanchion
Models:
 Non-Leveling
Version
6" High-3/8" Threaded Post
Part# FMJ-638L (Lag Bolt Version)
Part# FMJ-638T (Self tapping Screw Version)
Use this version when setting the Roof Trac support rail directly
on the Foam Jack post.
 Leveling
Kit Version
6" High-1/2" Threaded Post
Part# FMJ-612L (Lag Bolt Version)
Part# FMJ-612T (Self tapping Screw Version)
Like the best-selling Commercial Fast Jack, the Foam Jack is available
in a 1/2” thread version to accept the Commercial Leveling
Kit.
For use with the 1/2" commercial leveling
kit (sold separately)
Leveling
kit
Part# CFJ-LEVEL
For use with the FMJ-612L & FMJ-612T in conjunction with standard
outdoor rated strut to adjust for minor roof variances.
 Typical
Installation Sequence for Foaming
Step 1: Locate rafter/beam
Step 2: Use drill guide (sold separately) to drill a pilot
hole.
Step 3: Install base using appropriate fastener
Step 4: Place red cap on post and securely attach to base
Step 5: Clean and prepare the roof surface then foam the
stanchion
Step 6: When foam is dry, coat with UV paint
Step 7: Install your Rooftrac system!
Click here for a Foam
Jack data sheet in PDF
Call toll-free (877) 297-0014
for more information or to order.
|
