Solar grid tie
trace inverter

Xantrex - SW Series GTI Grid Tie Interface


Using the Xantrex Grid Tie Interface (GTI), the SW II inverter converts energy from multiple renewable energy sources, such as solar, wind, and microhydro, into AC power, selling power you don't use back to the utility. Software/hardware revision 4.2 or higher is required to connect the SW4024, SW4048, or SW5548 to the GTI.

Xantrex gti grid tie $427.00 - contact us
GTI Grid-Tie Interface Electrical Specifications
Utility Interactive Protection Over/under AC voltage and frequency detection plus active islanding detection
AC Voltage (Nominal) 120 VAC
AC Voltage (Allowed):  
Utility Interactive Mode 106 - 132 VAC
Bypass Mode (Adjustable) 80 - 149 VAC inverter controlled
Frequency (Allowed):  
Utility Interactive Mode 59.3 - 60.5 Hz
Bypass Mode (Adjustable) 53.0 - 67.0 Hz inverter controlled
AC Current (Allowed at 25 C):  
Utility Interactive Mode 40 amps continuous
Bypass Mode (Adjustable) 60 amps continuous
Total Output Harmonic Distortion  
Rated < 5% at full power
Typical 2.5% at full power
Power Factor (Allowed) > 94%
General Specifications
Enclosure Type Indoor, ventilated, steel chassis with white, powder coat finish
Unit Weight 26 lb (11.8 kg)
Dimensions (H x W x D) 6.3 x 21.0 x 7.0" (16 x 53.3 x 17.8 cm)
Mounting Wall mount in a horizontal position only with a mounting bracket
AC Input/Output Terminals Sized for #2 - 14# AWG wire
Conduit Sizes Dual 3/4" - 1" and 1/2" - 3/4" knockouts available
Warranty Two years
Part Number GTI
Regulatory Approvals
CSA Listed to UL1741 - 1st Edition
UL Listed to UL1741 - 1st Edition
 GTI Grid Tie Interface: $427.00 - contact us
Note: Specifications subject to change without notice.



Click on a link below:

Solar Modules
Charge Controllers





























©2001-2003 Solar Electric Supply
All Rights Reserved